Motion Control Products Ltd offers 12VDC or 24VDC brushed motor with wormwheel gearbox 73ZYT160-24-MCP4-25.1-BZ, ideal for the applications such as pigeon trap machine, electronic go karts and so forth.
Motion Control Products Ltd offers a number of 90mm dia. DC brushed motor with wormwheel MCP4 gearbox combinations, ideal for the applications such as clay pigeon trap machine, electric go karts, stairlifts and so forth.
Digital stepper drive DM805-AI from Motion Control Products Ltd is a digital stepper drive with built-in oscillator, supporting 0-5V analogue signal for speed controls. Supply voltage is up to +80VDC with output current (programmable) from 0.3A -5.0A(RMS
The high performance DMD556 digital stepper drive results from the use of new, patented 32-bit DSP control technology. Each DMD drive calculates its own natural system frequency and applies a damping control algorithm for superior anti-resonance.
Motion Control Products Ltd introduce DMD870 digital stepper drive (DM870) using a DSP with advanced control algorithm. It supports input voltage 72VDC with output current (programmable) from 0.5A to 7.0A (5.0RMS).
Our GD series linear actuators consist of an electric motor, gearbox and lead/ ballscrew that converts rotary motion into linear motion. It provides the thrust up to 2000N ideal for the use on caravan mover, auto windows/doors and medical beds etc.
Motion Control Products Ltd. offers MCP4 Wormwheel gearbox with hollow shaft design, gear ratio of 25:1 or 50:1. It is normally used together with our ZYT brushed motor. This type of gearbox is ideal for mobility cars, golf buggy, caravan mover and more
The MSD556 stepper drive is suitable for a wide range of stepping motors including our FL42, 57, 86 and the FL110 and are ideal for any application that requires a high performance but very low cost Microstepping drive.
The MSD752 /MSD752E microstepping drive is a high performance stepper drive based on latest 32 DSP technology, with supply voltage up to +68VDC and current of 5.2A.
Motion Control Products range of high torque NEMA 11 (28mm) hybrid stepper motors are available with a holding torque up to 117mNm. More torque than standard hybrid stepper motors due to the use of powerful rare earth magnets. 1.8 degrees-per-step, single
© 2020 Motion Control Products Ltd
| Terms of Service
| Job Opportunities