By implementing the latest motion control technologies, our new EM series, DSP-based digital stepper drives deliver excellent performance better than ever before: Unique features of sensorless stall detection, anti-resonance, extra smoothness and more...
Motion Control Products Ltd introduce DMD870 digital stepper drive (DM870) using a DSP with advanced control algorithm. It supports input voltage 72VDC with output current (programmable) from 0.5A to 7.0A (5.0RMS).
Digital stepper drive DM805-AI from Motion Control Products Ltd is a digital stepper drive with built-in oscillator, supporting 0-5V analogue signal for speed controls. Supply voltage is up to +80VDC with output current (programmable) from 0.3A -5.0A (RMS
Motion Control Products Ltd (MCP)'s new EM556-CAN stepper drive is one of the new high performance stepper drives which can support CANOpen communication protocol. Its input volt: 20 - 50VDC, output current up to 5.6A...
CS-D808 stepper drive is a closed-loop stepper drive with 20-80VDC inputs and up to 8.0A current at peak. With an advanced control algorithm, this drive can be used alone or to drive a 2-phase stepper motor in frame sizes NEMA 17, 23, 24, or 34 with incre
The high performance DMD556 digital stepper drive results from the use of new, patented 32-bit DSP control technology. Each DMD drive calculates its own natural system frequency and applies a damping control algorithm for superior anti-resonance.
As a replacement model to our old MSD980, MSD880 is a high performance microstepping drive based on pure-sinusoidal current control technology and the self-adjustment technology, with 80VDC inputs and 7.8A output current.
The MSD556 stepper drive is suitable for a wide range of stepping motors including our FL42, 57, 86 and the FL110 and are ideal for any application that requires a high performance but very low cost Microstepping drive.
The MSD752 /MSD752E microstepping drive is a high performance stepper drive based on latest 32 DSP technology, with supply voltage up to +68VDC and current of 5.2A.
The MSD542 stepper drive with 50VDC input and 4.1A is suitable for a wide range of stepping motors including our FL42, 57, 86 and the FL110 and are ideal for any application that requires a High performance but very low cost Microstepping drive.
As the direct replacement of our old MSD325 stepper drive, the DMD422 is a fully digital microstepping drive based on a DSP with advanced control algorithm. Microstep resolutions programmable (102,400 steps/rev); max. current 2.2A; Supply voltage upto 40V
© 2019 Motion Control Products Ltd
| Terms of Service
| Job Opportunities